Description
Remove Watermarks From Natural Stone Surfaces With The Epic Faber Extractor Powder Professional quality extraction powder that can be used to extract coloured stains The powder has to be mixed up with water to create a thick cream before using it It can be used on all types of natural stone surfaces like floors and vertical surfaces This product is effective and very gentle on the base material I Sold in 1 Kg buckets Safe to use on polished and unpolished natural stone surfaces, indoors and outdoors Highly effective against water marks, salt marks and most normal humidity stains The product has to be mixed up with warm water or Hydrogen Peroxide at 8% rate Create a creamy mixture and apply it directly to the affected areas in a thick layer The incredible Faber Extractor Powder has to be used by trained or qualified people Why Use It The new Faber Extractor Powder is a truly effective stain remover that can really help contractors remove humidity stains and water stains from a number of natural stone surfaces. This product is much more affordable than most types of stain removers and it can be used on horizontal and vertical surfaces. The product is as effective when used for treating indoor and outdoor surfaces. A bucket of 1.2 Kg will generate enough product to cover a large floor or wall area. To increase its efficiency, the incredible Faber Extractor Powder can also be mixed up with Hydrogen Peroxide. The product is highly effective on the stain itself but it will not damage the natural stone surface at all. Where To Use It Pretty much anywhere. It can be used for indoor and outdoor stain removing applications. The product can be mixed up in a thick composition to attach to vertical surfaces and even ceilings. If the natural staircase is affected by rising humidity and if the stone has visible water marks, then the new Faber Extractor Powder is the ideal solution for that particular issue. How To Use It Deep clean the surface and remove as much residue as possible before applying the incredible Faber Extractor Powder to the affected area. Do not use the new Faber Extractor Powder over dirty surfaces, in direct sunlight or on surfaces that have underfloor heating systems. Mix up the new Faber Extractor Powder with warm water or Hydrogen Peroxide until a thick composition is created. The composition can be as thick as required, depending on what type of surface it has to be applied to. A builder spatula should be used to apply an even and thick coat of the mixture all over the affected area. The product has to stay in direct contact with the affected area for at least 1-3 hours. Wash off the entire mixture with clean water and assess the results. If the results are less than satisfactory, repeat the operation. Our Recommendations This is a time consuming operation that needs to take its course and the step by step operation has to be followed. Do not use the product unless you are sure that you know how to use it and you understand the process. Do not use the new Faber Extractor Powder on artificial stones. Pre-test for compatibility before applying the product on a larger scale. Do not apply the mixture over wet surfaces. There is no exact amount of time needed to achieve results. In some cases the watermarks will disappear in seconds and in other cases it will require 2-3 stain removing operations for the stains to be removed. Safety Always follow the manufacturers instructions and safety guidelines for safe use. Wear suitable hand protection at all times and any other recommended PPE. Do not apply the product on any other surfaces that do not require a treatment. Do not mix up any other cleaning products with the powder to avoid unwanted reactions. Store in a cool, dry place safely out of reach of children. Faber Extractor Powder
